Bridgeport 2j head manual

 · The Bridgeport Manual for the J head mentions Lubriplate on page Lubrication. The manual I have also says to put a few drops in at the top from time to time. ISO AW hydraulic oil in the oil cups and one the drawbar. Lubriplate at set screw . Information in this manual is subject to change without notice. This manual covers installation, operation, maintenance, and parts list for Bridgeport Series I milling machines. In no event will Hardinge Inc. be responsible for indirect or consequential damage resulting . This document was created during the rebuild of my personal Bridgeport Series I J-Head, Stepped Pulley Mill. Much of the information presented in this document is from my own personal experiences, and all of the images that are located throughout the document were taken by me using a Nikon Coolpix and a Nikon www.doorway.ru Size: 2MB.

and versatility from Bridgeport heads. With Bridgeport head attachments, you can do jobs that normally would require special machinery. Ouillmaster Permits use of small tools at any compound angle with Model M, Model 2J and Model J heads. Supplements the right angle attachments described on this page. High spe'ed and rigidity allow the use of. Number of Pages: 56 This is a reproduction, not a photocopy, of an original Bridgeport 2hp. Variable Speed Motor Series I Installation, Operation, and Maintenance Manual. This manual covers the full milling machine and both the J and 2J mill heads. It includes good information on installing and adjusting all of the major parts. It [ ]. CNC Manual / Bridgeport / Bridgeport Series 1 Milling Machine with 2J Vari-Drive Head. Bridgeport Series 1 Milling Machine with 2J Vari-Drive Head. Views: Continue with reading or go to download page. Read Download. Recommended. Bridgeport DX32 CNC VMC Operators Manual. pages.

All part numbers and images were scanned from a Bridgeport Operators Manual. ** In the works is a Bridgeport repair and troubleshooting page, with how to's and other handy nice to have information. ** My BP 1J Mill (on dealers floor)kb. Milling Head Front View 1J 67kb. Milling Head Side View 1J 58kb. Power Feed (Original BP Type) 58kb. • 2 HP variable speed (with 2J head) • 3 HP 30 minute duty rate DRAWBAR When tightening or loosening the Drawbar “R”, Figure , it is necessary to lock the spindle. To accomplish this, use the spindle brake which is located on the left side of the belt housing, pulling. At this point you can loosen the four head T-bolt nuts. Now carefully crank the Y-axis handle and the whole head assembly will go straight out and straight back in again. Be carefull the head assembly is top heavy you may need assistance to balance the head. With it out you can replace the T-bolts (part# ), Head tilt adjusting Screw (part.